Otter-outdoors XT 650 Lodge Manuale Utente

Page 1Otter XT 650 LodgeInstallation and Set-Up InstructionsOtter XT 650 LodgeFits Magnum Otter Wild Sled OnlyParts Identification and Check ListPARTS

Fish House Fabric Use and Care GuideCare must be taken during use to avoid damaging the fabric. Follow these guidelines to help protect the fabric.

Page 21. Position sled (Item 1) as shownin Diagram 1, with curved frontto your left. Using front drillingpattern (on back page) marktwo holes for the

Page 36. Attach Back and Center main frame assemblies (Assembled in Step 5) onto frame brackets (Item 3 and 4).Secure with 1/4 nylon hex lock nut (Ite

Page 48. Attach Front main frame assembly (Assembled in Step 7) onto frame brackets (Item 3 and 4). Secure with 1/4nylon hex lock nut (Item 20). Ref.

Page 510. Attach Bottom main frame assembly (Assembled in Step 9) onto frame brackets (Item 3 and 4). Secure with 1/4nylon hex lock nut (Item 20). Ref

Page 612. Install wind support bars starting in back (Item 5), up through center (Item 6), then between the front and centermain frame bars (Item 7) a

Page 713. Slide the tent over the main frame barassembly, then fasten the velcro strapson the inside of the tent to each mainframe bar. Ref. Diagram 1

Page 815. On the front of the fishhouse, start in the corners and work inward, snap the plastic trim seal on the canvas tent(Item 2) to the top edge o

Page 9Otter XT 650 LodgeOctober, 2013Otter Outdoors Inc.411 W Congress St. • Maple Lake, MN 55358Phone 320-963-6480 • www.otteroutdoors.comOUTSIDE EDG